Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 994)

984 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
14
Syntax:
dns-snoop entry-timeout <30-86400>
Parameters
dns-snoop entry-timeout <30-86400>
Example
rfs7000-37FABE(config-fw-policy-test)#dns-snoop entry-timeout 35
rfs7000-37FABE(config-fw-policy-test)#show context
firewall-policy test
no ip dos tcp-sequence-past-window
dhcp-offer-convert
dns-snoop entry-timeout 35
rfs7000-37FABE(config-fw-policy-test)#
Related Commands:
firewall
firewall-policy
Enables a device’s firewall
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
firewall enable
Parameters
firewall enable
Example
rfs7000-37FABE(config-fw-policy-default)#firewall enable
rfs7000-37FABE(config-fw-policy-default)#
entry-timeout
<30-86400> Sets the DNS snoop table entry timeout interval from 30 - 86400 seconds. An entry is retained in the
DNS snoop table only for the specified time, and is deleted once this time is exceeded. The default is
1,800 seconds.
no Removes the DNS snoop table entry timeout interval
firewall enable Enables wireless firewalls