L2tpv3-tunnel-commands – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1209
Brocade Mobility RFS Controller CLI Reference Guide
1201
53-1003098-01
23
l2tpv3 policy L2TPV3Policy1
hello-interval 200
retry-attempts 10
retry-interval 30
cookie-size 8
rx-window-size 9
tx-window-size 9
reconnect-interval 100
reconnect-attempts 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
l2tpv3-tunnel-commands
Use the (profile or device context) instance to configure a L2TPv3 tunnel. To navigate to the tunnel
configuration mode, use the following command in the profile context:
rfs7000-37FABE(config-profile-default-rfs7000)#l2tpv3 tunnel Tunnel1
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#?
L2tpv3 Tunnel Mode commands:
L2tpv3 Tunnel Mode commands:
establishment-criteria Set tunnel establishment criteria
hostname Tunnel specific local hostname
local-ip-address Configure the IP address for tunnel. If not
specified, tunnel source ip address would be chosen
automatically based on the tunnel peer ip address
mtu Configure the mtu size for the tunnel
no Negate a command or set its defaults
peer Configure the l2tpv3 tunnel peers. At least one peer
must be specified
router-id Tunnel specific local router ID
session Create / modify the specified l2tpv3 session
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
Resets the number of packets transmitted without receiving an acknowledgment to default (10
packets)