Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 560)

Brocade Mobility RFS Controller CLI Reference Guide 547
53-1003098-01
7
alias vlan <1-4094>
Parameters
alias address-range to
alias host
alias network
alias network-group [address-range to
{ to }|host {}|
network {}]
address-range
ME> Creates a new address-range alias for this profile. Or associates an existing address-range alias with this
profile. An address-range alias maps a name to a range of IP addresses.
•
– Specify the address range alias name.
Alias name should begin with ‘$’.
to Associates a range of IP addresses with this address range alias
•
– Specify the first IP address in the range.
•
to – Specify the last IP address in the range.
If using an existing address-range alias, you can apply overrides to the alias at the profile level.
host
Creates a new host alias for this profile. Or associates an existing host alias with this profile. A host alias
maps a name to a single network host.
•
– Specify the host alias name.
Alias name should begin with ‘$’.
Associates the network host’s IP address with this host alias
•
– Specify the network host’s IP address.
If using an existing host alias, you can apply overrides to the alias at the profile level
network
Creates a new network alias for this profile. Or associates an existing network alias with this profile. A
network alias maps a name to a single network address.
•
– Specify the network alias name.
Alias name should begin with ‘$’.
SK> Associates a single network with this network alias
•
– Specify the network’s address and mask.
If using an existing network alias, you can apply overrides to the alias at the profile level.
network
NAME> Creates a new network-group alias for this profile. Or associates an existing network-group alias with this
profile.
•
– Specify the network-group alias name.
Alias name should begin with ‘$’.
The network-group aliases are used in ACLs, to define the network-specific components. ACLs using aliases
can be used across sites by re-defining the network-group alias elements at the device or profile level.
After specifying the name, specify the following: a range of IP addresses, host addresses, or a range of
network addresses.
If using an existing network-group alias, you can apply overrides to the alias at the profile level.
address-range
to
{
to } Associates a range of IP addresses with this network-group alias
•
– Specify the first IP address in the range.
•
to – Specify the last IP address in the range.
•
to – Optional. Specifies more than one range of IP
addresses. A maximum of eight (8) IP address ranges can be configured.