Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1201)

Brocade Mobility RFS Controller CLI Reference Guide 1193
53-1003098-01
23
fail-over <5-60>
Example
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#failover-delay 30
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
hello-interval 200
failover-delay 30
retry-attempts 10
retry-interval 30
cookie-size 8
rx-window-size 9
tx-window-size 9
reconnect-interval 100
reconnect-attempts 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
force-12-path-recovery
l2tpv3-policy-commands
Enables the forced detection of servers and gateways behind the L2TPv3 tunnel. This feature is
disabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
force-12-path-recovery
Parameters
None
Example
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#force-l2-path-recovery
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
hello-interval 200
failover-delay 30
fail-over <5-60> Sets the delay interval to re-establish a failed L2TPv3 tunnel (RF-Domain manager/
VRRP-master/Cluster-master failover)
•
<5-60> – Specify a failover delay from 5 - 60 seconds. The default is 5 seconds.
no Resets the failover interval to its default (5 seconds)