Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 706)

Brocade Mobility RFS Controller CLI Reference Guide 693
53-1003098-01
7
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#antenna-gain 12.0
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
antenna-gain 12.0
aggregation ampdu tx-only
aeroscout forward
antenna-diversity
airtime-fairness prefer-ht weight 6
antenna-downtilt
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
antenna-mode
interface-config-radio-instance
Configures the antenna mode (the number of transmit and receive antennas) on the radio
This command sets the number of transmit and receive antennas on the access point. The 1x1
mode is used for transmissions over just the single -A- antenna, 1xALL is used for transmissions
over the -A- antenna and all three antennas for receiving. The 2x2 mode is used for transmissions
and receipts over two antennas for dual antenna models. The default setting is dynamic based on
the access point model deployed and its transmit power settings.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
antenna-mode [1*1|1*ALL|2*2|default]
Parameters
antenna-mode [1*1|1*ALL|2*2|default]
Usage Guidelines:
To support STBC feature on Brocade Mobility 71XX Access Point profile, the antenna-mode should
not be configured to 1x1.
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#antenna-mode 2x2
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
no Resets the radio’s antenna gain parameter
1*1 Uses only antenna A to receive and transmit
1*ALL Uses antenna A to transmit and receives on all antennas
2*2 Uses antenna A and C for both transmit and receive
default Uses default antenna settings. This is the default setting.