Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 856)

Brocade Mobility RFS Controller CLI Reference Guide 843
53-1003098-01
8
An AAA server could go offline. When a server goes offline, it is marked as down. This command
configures the interval after which a server marked as down is checked to see if it has come back
online and is reachable.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
health-check interval <60-86400>
Parameters
health-check interval <60-86400>
Example
rfs7000-37FABE(config-aaa-policy-test)#health-check interval 4000
rfs7000-37FABE(config-aaa-policy-test)#show context
aaa-policy test
authentication server 5 host 172.16.10.10 secret 0 example port 1009
authentication server 5 timeout 10
accounting server 2 host 172.16.10.10 secret 0 example port 1
accounting server 2 timeout 2 attempts 2
authentication protocol chap
accounting interim interval 65
accounting server preference auth-server-number
health-check interval 4000
attribute framed-mtu 110
rfs7000-37FABE(config-aaa-policy-test)#
Related Commands:
mac-address-format
aaa-policy
Configures the format MAC addresses are filled in RADIUS request frames
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
interval <60-86400> Configures an interval (in seconds) after which a down server is checked to see if it is reachable again
•
<60-86400> – Specify a value from 60 - 86400 seconds.
no Resets the health-check interval for AAA servers