Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1311)

Brocade Mobility RFS Controller CLI Reference Guide 1303
53-1003098-01
27
no root-select cost-root
no preferred [interface|root|neighbor]
Parameters
no acs [channel-hold-time|channel-switch-delta|channel-width|ocs-duration|
ocs-frequency|path-min|path-threshold|priority-meshpoint|sample-count|snr-del
ta|
signal-threshold|tolerance-period] [2.4GHZ|5GHz]
no exclude wired-peer mint-level-1
no hysteresis [min-threshold|period|root-sel-snr-delta|snr-delta]
no monitor [critical-resource|primary-port-link-loss]
no [path-method|root {select-method}]
no root-select cost-root]
no acs Reverts the automatic channel selection settings to default
channel-hold-time Reverts channel hold time to default (1800 seconds)
channel-switch-delta Reverts channel switch delta to default (10 dBm)
channel-width Reverts channel width to default (auto)
ocs-duration Reverts off -channel scan duration to default (50 milliseconds)
ocs-frequency Reverts off -channel scan frequency to default (6 seconds)
path-min Reverts the minimum root path metric to default (1000)
path-threshold Reverts the root path metric threshold to default (1500)
priority-meshpoint Disables the priority meshpoint configuration
sample-count Reverts the sample count to default (5 samples)
snr-delta Reverts the channel SNR delta to default (5 db)
signal-threshold Reverts the signal strength threshold to default (-65 dB)
tolerance-period Reverts the tolerance period to default (60 seconds)
no exclude wired-peer Disables exclusion of wired peers (wired mesh devices) with MiNT level-1 link
no hysteresis [min-threshold|
period|root-sel-snr-delta|
snr-delta] Removes the configured path selection SNR hysteresis values
no monitor critical-resource Disables critical resource down event monitoring
no monitor primary-port-link-loss Disables primary port link loss event monitoring
no root select-method Removes the configuration of this meshpoint device as a root meshpoint. Also allows you to disable
dynamic mesh selection (if enabled).
no path-method Resets the path selection method (path to the root node) to default (uniform)
no root-select cost-root Removes the selected meshpoint-device as the cost-root