Domain-name – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1318
1310
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
28
connection-capability ip-protocol <0-255> port <0-65535> [closed|open|unknown]
Example
rfs4000-229D58(config-passpoint-policy-test)#connection-capability 1
ip-protocol 2 port 10 closed
rfs4000-229D58(config-passpoint-policy-test)#
rfs4000-229D58(config-passpoint-policy-test)#show context
hotspot2-policy test
access-network-type chargeable-public
connection-capability ip-protocol 2 port 10 closed
3gpp mcc 310 mnc 970
3gpp mcc 505 mnc 14
rfs4000-229D58(config-passpoint-policy-test)#
Related Commands:
domain-name
Configures the RF Domain(s) that are returned in response to an ANQP query
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
tls-vpn
Specifies the protocol type as TLS VPN. Configures TCP port 443.
port <0-65535>
[closed|open|unknown]
After specifying the protocol type, specify the port (associated with the selected protocol) and its status.
•
closed – Specifies that the port(s) is/are closed
•
open – Specifies that the port(s) is/are open
•
unknown – Specifies that the port(s) status is not known
When the connection capability element is not configured, the hotspot does not return the element in an
ANQP capability request and ignores any ANQP query for the element.
connection-capability
Configures the connection capability element in this passpoint policy
ip-protocol <0-255>
Identifies the IP protocol by the protocol’s number. For example, for simple message protocol (SMP)
specify 121.
port <0-65535>
[closed|open|unknown]
After specifying the IP protocol type, specify the port number.
•
port <0-65535> – Select a port for the IP protocol identified.
After specifying the port number, specify the port status.
•
closed – Specifies that the port(s) is/are closed
•
open – Specifies that the port(s) is/are open
•
unknown – Specifies that the port(s) status is not known
When the connection capability element is not configured, the hotspot does not return the element in an
ANQP capability request and ignores any ANQP query for the element.
Removes the configured connection capability element on the passpoint policy