Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 556
Brocade Mobility RFS Controller CLI Reference Guide
543
53-1003098-01
7
Configures bridge specific parameters
configures captive portal advanced Web page upload on a device profile
Enables Cisco Discovery Protocol (CDP) on a device
Configures a cluster name
Enables persistence of configuration across reloads
Configures a wireless controller or service platform
Monitors user configured IP addresses and logs their status
Configures data encryption related protocols and settings
Configures device firmware upgrade settings on this profile
Configures 802.1x standard authentication controls
Configures an IP DSCP to 802.1p priority mapping for untagged frames
Configures e-mail notification
Enables checking of a device’s firmware version before attempting adoption or clustering
Configures the environmental sensor settings on this profile
Displays system event messages
Enables export of startup.log file after every boot
Sets the floor name where the system is located
Enables Generic Routing Encapsulation (GRE) tunneling on this profile
Configures HTTP analysis settings
Configures an interface (VLAN, radio, GE etc.)
Configures IP components
Defines the Layer 2 Tunnel Protocol (L2TP) protocol for tunneling layer 2 payloads using
Virtual Private Networks (VPNs)
Configures L3e Lite Table with this profile
Turns device LEDs on or off
Configures LED-timeout timer. This command is specific to the NX9000 series service
platforms.
Auto downgrades a legacy device firmware
Auto upgrades a legacy device firmware
Configures Link Layer Discovery Protocol (LLDP)
Configures load balancing parameters
Modifies message logging
Configures the MAC address table
Enables 802.1x user authentication protocol on this profile
Configures the memory profile used on the device
TABLE 5
Profile-Config Commands
Command
Description
Reference