Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 328)

312 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
role-policy
Parameters
role-policy
Example
rfs7000-37FABE(config)#routing-policy TestRoutingPolicy
rfs7000-37FABE(config-routing-policy-TestRoutingPolicy)#?
Routing Policy Mode commands:
apply-to-local-packets Use Policy Based Routing for packets generated by
the device
logging Enable logging for this Route Map
no Negate a command or set its defaults
route-map Create a Route Map
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-routing-policy-TestRoutingPolicy)#
NOTE
For more information on routing policy commands, see Chapter 25, ROUTING-POLICY .
Related Commands:
self
Global Configuration Commands
Displays the device’s configuration context
Supported in the following platforms:
Specify the role policy name. If the policy does not exist, it is created.
no Removes an existing routing policy