Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 669)

656 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
ip Internet Protocol (IP)
no Negate a command or set its defaults
qos Quality of service
switchport Set switching mode characteristics
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
nx4500-5CFA2B(config-profile-testNX45XX-if-vmif2)#
Related Commands:
interface-config-instance
interface
Use the config-profile- instance to configure the Ethernet, VLAN and tunnel
associated with the
access point, wireless controller, or service platform.
To switch to this mode, use the following command:
(config-profile-)#interface [|fe
<1-4>|
ge <1-8>|me1|port-channel <1-4>|pppoe1|radio [1|2|3]|up1|vlan
<1-4094>|wwan1|xge <1-4>]
(config-profile-default-rfs7000)# ge 1
The following example uses the config-profile-default-rfs7000 instance to
configure a GigabitEthernet interface:
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#?
Interface configuration commands:
cdp Cisco Discovery Protocol
channel-group Channel group commands
description Interface specific description
dot1x 802.1X
duplex Set duplex to interface
ip Internet Protocol (IP)
lldp Link Local Discovery Protocol
mac-auth Enable mac-auth for this port
no Negate a command or set its defaults
power PoE Command
qos Quality of service
shutdown Shutdown the selected interface
spanning-tree Spanning tree commands
speed Configure speed
switchport Set switching mode characteristics
no Removes the selected interface