Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 594
Brocade Mobility RFS Controller CLI Reference Guide
581
53-1003098-01
7
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
critical-resource [
critical-resource
critical-resource
arp-only vlan <1-4094> {
<1-4>|port-channel <1-2>]}}
critical-resource
[
pppoe1|vlan|wwan1]
critical-resource
[
pppoe1|vlan <1-4094>|wwan1] [all|any]
<1-4094>
{
critical-resource monitor interval <5-86400>
Parameters
critical-resource
arp-only vlan <1-4094> {
<1-2>]}}
Specify the critical resource name
monitor
Monitors configured critical resource(s)
direct
[all|any]
Monitors critical resources using the default routing engine
•
all – Monitors all resources that are going down (generates an event when all specified critical
resources are unreachable)
•
any – Monitors any resource that is going down (generates an event when any one of the specified
critical resource is unreachable)
Specifies the IP address to monitor
arp-only
vlan <1-4094>
{
port [
ge|port-channel]}
The following keywords are common to the ‘all’ and ‘any’ parameters:
•
arp-only vlan <1-4094> – Optional. Uses ARP to determine if the IP address is reachable (use this
option to monitor resources that do not have IP addresses). ARP is used to resolve hardware
addresses when only the network layer address is known.
•
vlan <1-4094> – Specifies the VLAN ID on which to send the probing ARP requests. Specify the
VLAN ID from 1 - 4094.
•
•
port [