Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 105)

88 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
clear gre stats {on }
clear ip dhcp bindings [|all] {on }
clear ip ospf process {on }
clear l2tpv3-stats tunnel {on |session
NAME> {on }}
flows Clears established firewall sessions
on The following keywords are common to the DHCP, DOS, and flows parameters:
•
on – Optional. Clears DHCP snoop table entries, denial of service statistics, or the
established firewall sessions on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.
gre stats Clears GRE tunnel statistics
on Optional. GRE tunnel statistics on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.
ip Clears a Dynamic Host Configuration Protocol (DHCP) server’s IP address bindings entries
dhcp bindings Clears DHCP server’s connections and address binding entries
Clears specific address binding entries. Specify the IP address to clear binding entries.
all Clears all address binding entries
on Optional. Clears a specified address binding or all address bindings on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.
ip ospf process Clears already enabled open shortest path first (OSPF) process and restarts the process
on Optional. Clears OSPF process on a specified device
OSPF is a link-state interior gateway protocol (IGP). OSPF routes IP packets within a single routing domain
(autonomous system), like an enterprise LAN. OSPF gathers link state information from neighbor routers
and constructs a network topology. The topology determines the routing table presented to the Internet
layer which makes routing decisions based solely on the destination IP address found in IP packets.
•
– Specify the name of the AP, wireless controller, or service platform.
l2tpv3-stats Clears L2TPv3 tunnel session statistics
tunnel
Clears all sessions associated with a specified L2TPv3 tunnel
•
– Specify the L2TPv3 tunnel name.
{on |
session NAME> {on }} Use the following optional parameters to specify a session or device.
•
on – Optional. Clears all sessions associated with the specified L2TPv3 tunnel
running on a specified device
•
DEVICE-NAME> – Specify the name of the AP, wireless controller, or
service platform.
•
session – Optional. Clears a specified L2TPv3 tunnel session. Specify the
session name.
•
on – Optional. Specifies the device running the L2TPv3 tunnel session
•
DEVICE-NAME> – Specify the name of the AP, wireless controller, or
service platform.
If no optional parameters are specified, the system clears all L2TPv3 tunnel session statistics.