Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1151)

Brocade Mobility RFS Controller CLI Reference Guide 1143
53-1003098-01
20
smart-ocs-monitoring {power-save-aware [2.4GHz|5GHz]
[disable|dynamic|strict]}
smart-ocs-monitoring {sample-count [2.4GHz|5GHz] <1-15>}
smart-ocs-monitoring {voice-aware [2.4GHz|5GHz] [disable|dynamic|strict]}
Example
rfs7000-37FABE(config-smart-rf-policy-test)#smart-ocs-monitoring
extended-scan-frequency 2.4Ghz 9
rfs7000-37FABE(config-smart-rf-policy-test)#smart-ocs-monitoring sample-count
2.4Ghz 3
rfs7000-37FABE(config-smart-rf-policy-test)#show context
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
group-by floor
power-save-aware Optional. Enables power save awareness scanning mode on this Smart RF policy. The options are:
disable, dynamic, and strict.
This setting allows Smart RF to detect power save clients and take them into consideration when
performing off channel scans.
Strict disables smart monitoring as long as a power save capable client is associated to a radio.
Dynamic disables smart monitoring as long as there is data buffered for a power save client at the radio.
2.4GHz [dynamic|strict] Sets power save awareness scanning mode on the 2.4 GHz band
•
disable – Disables power save awareness scanning
•
dynamic – Dynamically avoids scanning based on traffic for power save (PSP) clients
•
strict – Strictly avoids scanning when PSP clients are present
The default is dynamic.
5GHz [dynamic|strict] Sets power save awareness scanning mode on the 5.0 GHz band
•
disable – Disables power save awareness scanning
•
dynamic – Dynamically avoids scanning based on traffic for PSP clients
•
strict – Strictly avoids scanning when PSP clients are present
The default is dynamic.
sample-count Optional. Specifies the number of samples to collect before reporting an issue to the Smart RF master
2.4GHz <1-15> Selects the 2.4 GHz band
•
<1-15> – Specifies the number of samples to collect from 1 - 15. The default is 10.
5GHz <1-15> Selects the 5.0 GHz band
•
<1-15> – Specifies the number of samples to collect from 1 - 15. The default is 5.
voice-aware Optional. Enables voice awareness scanning mode on this Smart RF policy. The options are: disable,
dynamic, and strict.
Strict disables smart monitoring as long as a voice client is associated to a radio. Dynamic disables
smart monitoring as long as there is data buffered for a voice client at the radio.
2.4GHz [dynamic|strict] Specifies the scanning mode on the 2.4 GHz band
•
disable – Disables voice awareness scanning
•
dynamic – Dynamically avoids scanning based on traffic for voice clients
•
strict – Strictly avoids scanning when voice clients are present
NOTE: The default is dynamic.
5GHz [dynamic|strict] Specifies the scanning mode on the 5.0 GHz band
•
dynamic – Dynamically avoids scanning based on traffic for voice clients
•
strict – Strictly avoids scanning when voice clients are present.
NOTE: The default is dynamic.