Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1144)

1136 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
20
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
group-by floor
sensitivity custom
assignable-power 5GHz min 8
assignable-power 5GHz max 20
channel-list 2.4GHz 1,12
channel-width 5GHz auto
interference-recovery channel-switch-delta 5GHz 5
coverage-hole-recovery snr-threshold 5GHz 1
rfs7000-37FABE(config-smart-rf-policy-test)#
Related Commands:
neighbor-recovery
smart-rf-policy
Enables recovery from errors due to faulty neighboring radios. Enabling neighbor recovery ensures
automatic recovery from failed radios within the radio coverage area. Smart RF instructs
neighboring access points to increase their transmit power to compensate for the failed radio.
Neighbor recovery is enabled by default when the sensitivity setting is medium.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
neighbor-recovery {dynamic-sampling|power-hold-time|power-threshold}
neighbor-recovery {dynamic-sampling} {retries <1-10>|threshold <1-30>}
neighbor-recovery {power-hold-time <0-3600>}
neighbor-recovery {power-threshold [2.4Ghz|5Ghz] <-85--55>}
Parameters
neighbor-recovery {dynamic-sampling} {retries <1-10>|threshold <1-30>}
no Disables recovery from excessive noise and interference
dynamic-sampling Optional. Configures dynamic sampling on this Smart RF policy
retries <1-10> Optional. Specifies the number of retries before allowing a power level adjustments to compensate for a
potential coverage hole.
•
<1-10> – Sets the number of retries from 1 - 10. The default is 3.
threshold <1-30> Optional. Specifies the minimum number of sample reports before which a power change requires
dynamic sampling
•
<1-30> – Sets the minimum number of reports from 1 - 30. The default is 5.