Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 932
920
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
12
disable [deny|permit] [
[
<0-7>,type [8021q|
<1-65535>|aarp|appletalk|arp|ip|ipv6|ipx|mint|rarp|wisp],vlan
<1-4095>) log
(rule-recedence <1-5000>) {(rule-description
Parameters
disable [deny|permit] [
[
[8021q|
<1-65535>|aarp|appletalk|arp|ip|ipv6|ipx|mint|rarp|wisp],vlan <1-4095>) log
(rule-recedence <1-5000>) {(rule-description
Example
The following example shows the MAC access list ‘test’ settings before the
‘disable’ command is executed:
disable [deny|permit]
Disables a deny or permit access rule without removing it from the MAC ACL
Provide the exact values used to configure the deny or permit rule that is to be disabled.
Specifies the source MAC address and mask to match
•
•
any
Select ‘any’ if the rule is applicable to any source MAC address
host
Specify the source host’s exact MAC address
Specifies the destination MAC address and mask to match
•
•
any
Select ‘any’ if the rule is applicable to any destination MAC address
host
Specify the destination host’s exact MAC address
log
The following keyword defines the action taken when a packet matches any or all of the above specified
criteria
•
log – Logs a record. when a packet matches the specified criteria
dotp1p <0-7>
Specify the 802.1p priority from 0 - 7.
type
[8021q|<1-65535>|
aarp|appletalk|
arp|ip|ipv6|ipx|mint|
rarp|wisp]
Use the available options to specify the EtherType value.
vlan <1-4095>
Specify the VLAN ID(s)
log
Select log, if the rule has been configured to log records in case of a match.
rule-precedence
<1-5000>
{(rule-description
The following keywords are recursive and common to all of the above parameters:
•
rule-precedence – Provide the precedence assigned to this deny or permit rule.
•
<1-5000> – Specify a value from 1 - 5000. The rule with the specified precedence is removed form
the MAC ACL.
•
rule-description