Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 655)

642 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
export
Profile Config Commands
Enables export of startup.log file after every boot
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
export startup-log [max-retries|retry-interval|url]
export startup-log [max-retries <2-65535>|retry-interval <30-86400>|url ]
Parameters
export startup-log [max-retries <2-65535>|retry-interval <30-86400>|url ]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#export startup-log max-retries
10
retry-interval 30 url [email protected]
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
......................................................
qos trust dscp
qos trust 802.1p
interface ge4
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface pppoe1
use firewall-policy default
export startup-log max-retries 10 retry-interval 30 url
[email protected]
service pm sys-restart
router ospf
rfs7000-37FABE(config-profile-default-rfs7000)#
export startup-log Enables export of the startup.log file after every boot
max-retries
<2-65535> Configures the maximum number of retries in case the export process fails
•
<2-65535> – Specify a value from 2 - 65535.
retry-interval
<30-86400> Configures the interval between two consecutive retries
•
<30-86400> – Specify a value from 30 - 86400 seconds.
url Configures the destination URL in the following format:
tftp://[:port]/path/file
ftp://:@[:port]/path/file
sftp://@[:port]>/path/file