Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 430)

Brocade Mobility RFS Controller CLI Reference Guide 415
53-1003098-01
5
service pktcap on radio [<1-1024>|all] {(acl-name ,count
<1-1000000>,direction [any|inbound|outbound],filter
,hex,promiscuous,rate <1-100>,snap <1-2048>,
tcpdump,verbose,write [file|url|tzsp ])}
service pktcap on interface [|ge <1-4>|me|port-channel <1-2>|vlan
<1-4094] {(acl-name ,count <1-1000000>,direction
[any|inbound|outbound],filter ,hex,rate <1-100>,snap
<1-2048>,tcpdump,verbose,write [file|url|tzsp ])}
pktcap on radio Captures data packets on a radio (802.11)
<1-1024> Captures data packets on a specified radio
•
<1-1024> – specify the radio index from 1 - 1024.
all Captures data packets on all radios
acl-name Optional. Specify the ACL that matches the ACL name for the 'deny' location
count <1-1000000> Optional. Sets a specified number of packets to capture
•
<1-1000000> – Specify a value from 1 - 1000000.
direction
[any|inbound|outbound] Optional. Changes the packet direction with respect to a device. The direction can be set as any, inbound, or
outbound.
filter Optional. Filters packets based on the option selected (must be used as a last option)
•
– Define a packet capture filter or select any one of the available options.
hex Optional. Provides binary output of the captured packets
rate <1-100> Optional. Specifies the packet capture rate
•
<1-100> – Specify a value from 1 - 100 seconds.
snap <1-2048> Optional. Captures the data length
•
<1-2048> – Specify a value from 1 - 2048 characters.
tcpdump Optional. Decodes the TCP dump
verbose Optional. Provides verbose output
write Captures packets to a specified file. Provide the file name and location in the following format:
FILE – flash:/path/file
cf:/path/file
usb1:/path/file
usb2:/path/file
nvram:startup-config
URL – tftp://[:port]/path/file
ftp://:@[:port]/path/file
sftp://@[:port]>/path/file
tzsp – The TZSP host. Specify the TZSP host’s IP address or hostname.
pktcap on Captures data packets at a specified interface
•
on – Specify the capture location.
interface [|
ge <1-4>|me1|
port-channel <1-2>|
vlan <1-4094>] Captures packets at a specified interface. The options are:
•
– Specify the interface name.
•
ge <1-4> – Selects a GigabitEthernet interface index from 1 - 4
•
me1 – Selects the FastEthernet interface
•
port-channel <1-2> – Selects a port-channel interface index from 1- 2
•
vlan <1-4094> – Selects a VLAN ID from 1 - 4094
acl-name Optional. Specify the ACL that matches the ACL name for the 'deny' location
count <1-1000000> Optional. Sets a specified number of packets to capture
•
<1-1000000> – Specify a value from 1 - 1000000.