Data-limit – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 200
184
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
custom-auth info
Example
rfs7000-37FABE(config-captive-portal-test)#custom-auth info bob,
rfs7000-37FABE(config-captive-portal-test)#show context
captive-portal test
access-type logging
access-time 35
custom-auth info bob,\ [email protected]
connection-mode https
accounting syslog host 172.16.10.13 port 1
rfs7000-37FABE(config-captive-portal-test)#
Related Commands:
data-limit
Enforces data transfer limits on captive portal clients. This feature enables the tracking and logging
of user usage. Users exceeding the allowed bandwidth are restricted from the captive portal.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
data-limit <1-102400> {action [log-and-disconnect|log-only]}
Parameters
data-limit <1-102400> {action [log-and-disconnect|log-only]}
info
Configures information used for RADIUS lookup when custom-auth RADIUS access type is configured
•
number of the user.
Removes custom user information configured with this captive portal
data-limit <1-102400>
Sets a captive portal client’s data transfer limit in megabytes. This limit is applicable for both upstream and
downstream data transfer.
•
<1-102400> – Specify a value from 1 - 102400 MB.
action
[log-and-disconnect|
log-only]
Optional. Specifies the action taken when a client exceeds the configured data limit. The options are:
•
log-and-disconnect – Logs a record and disconnects the client
•
log-only – Only a log is generated and the client remains connected to the captive portal. This is the
default setting.