Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 459)

Brocade Mobility RFS Controller CLI Reference Guide 445
53-1003098-01
6
IP Address: 169.254.230.196
Platform: Brocade Mobility 7131 Access Point, Capabilities: Router Switch
Interface: ge1, Port ID (outgoing port): ge1
Hold Time: 131 sec
advertisement version: 2
Native VLAN: 1
Duplex: full
Version :
5.4.1.0-018R
-------------------------
Device ID: br7131-139B34
Entry address(es):
IP Address: 172.16.10.22
Platform: AP7131N, Capabilities: Router Switch
Interface: ge1, Port ID (outgoing port): ge1
Hold Time: 129 sec
--More--
rfs7000-37FABE(config)#
The following example shows a non-detailed CDP neighbors table:
rfs7000-37FABE(config)#show cdp neighbors on rfs7000-37FABE
-----------------------------------------------------------------------------
---
Device ID Neighbor IP Platform Local Intrfce Port ID Duplex
-----------------------------------------------------------------------------
---
br7131-11E6C4 172.16.10.23 AP7131 ge1 ge1 full
br7131-139B34 172.16.10.22 AP7131N ge1 ge1 full
-----------------------------------------------------------------------------
---
rfs7000-37FABE(config)#
clock
show commands
Displays a selected system’s clock
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show clock {on }
Parameters