Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 512)

498 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
Parameters
show rtls [aeroscout|ekahau] {} {(on )}
Example
rfs4000-229D58(config)#show rtls aeroscout
Aeroscout Engine IP: 0.0.0.0 Port: 0
Send Count : 0
Recv Count : 0
Tag Reports : 0
Nacks : 0
Acks : 0
Lbs : 0
AP Status : 0
AP Notif : 0
Send Err : 0
Errmsg Count : 0
Total number of APs displayed: 1
rfs4000-229D58(config)#
running-config
show commands
Displays configuration files (where all configured MAC and IP access lists are applied to an
interface)
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show running-config
{aaa-policy|association-acl-policy|auto-provisioning-policy|
captive-portal-policy|device|dhcp-server-policy|firewall-policy|include-facto
rtls Displays access point RTLS statistics
aeroscout Displays access point Aeroscout statistics
ekahau Displays access point Ekahau statistics
Optional. Displays Aeroscout or Ekahau statistics for a specified access point. Specify the MAC address or
hostname of the access point.
on
> The following keyword is recursive and common to ‘Aeroscout’ and ‘Ekahau’ parameters:
•
on – Optional. Displays Aeroscout or Ekahau statistics on a specified
device or domain.
•
– Specify the name of the AP, wireless controller, service platform, or
RF Domain.