Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1235)

Brocade Mobility RFS Controller CLI Reference Guide 1227
53-1003098-01
24
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
area-type [nssa|stub]
area-type nssa {default-cost|no-summary|translate-always|translate-candidate|
translate-never}
area-type nssa {default-cost <0-16777215> {no-summary}|no-summary
{default-cost
<0-16777215>}}
area-type nssa {translate-always|translate-candidate|translate-never}
{(default-cost <0-16777215>|no-summary)}
area-type stub {default-cost <0-16777215> {no-summary}|no-summary
{default-cost
<0-16777215>}}
Parameters
area-type [nssa|stub]
Example
rfs7000-37FABE(config-profile
default-rfs7000-router-ospf-area-0.0.0.1)#area-type stub default-cost 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf-area-0.0.0.1)#show
con
text
area 0.0.0.1
area-type stub default-cost 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf-area-0.0.0.1)#
Related Commands:
authentication
OSPF-area-mode
Specifies an authentication scheme used for an OSPF area used with the OSPF dynamic route
Supported in the following platforms:
nssa Configures the OSPF area as NSSA
stub Configures the OSPF area as Stubby Area (STUB)
default-cost
<0-16777215> Specifies the default summary cost that will be advertised, if the OSPF area is a STUB or NSSA
•
<0-16777215> – Specify the default summary cost value from 0 - 16777215.
no-summary Configures the OSPF area as totally STUB if the area-type is STUB or totally NSSA if the area-type is NSSA
translate-always Always translates type-7 Link State Advertisements (LSAs) into type-5 LSAs
translate-candidate Defines it as default behavior
translate-never Never translates type-7 LSAs into type-5 LSAs
no Removes configured area-type settings