Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1215)

Brocade Mobility RFS Controller CLI Reference Guide 1207
53-1003098-01
23
Related Commands:
peer
l2tpv3-tunnel-commands
Configures the L2TPv3 tunnel’s peers. At least one peer must be specified.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
peer <1-2> {hostname|ip-address|ipsec-secure|router-id|udp}
peer <1-2> {hostname [|any]} {ipsec-secure|router-id|udp}
peer <1-2> {ip-address } {hostname|ipsec-secure|router-id|udp}
peer <1-2> {ipsec-secure} {gw [|]}
peer <1-2> {router-id [||any]} {ipsec-secure|udp}
peer <1-2> {udp} {ipsec-secure|port <1-65535>}
Parameters
peer <1-2> {hostname [|any]} {ipsec-secure|router-id|udp}
establishment-criteria Configures a L2TPv3 tunnel’s establishment criteria
hostname Configures the tunnel’s local hostname
local-ip-address Configures the tunnel’s source IP address
mtu Configures the MTU size for this tunnel
peer Configures the tunnel’s peers
router-id Configures the tunnel’s local router ID
session Creates/modifies specified L2TPv3 session
use Associates a specified L2TPv3 tunnel policy with a L2TPv3 tunnel
peer <1-2> Configures the tunnel’s peer ID from 1 - 2
NOTE: At any time the tunnel is established with only one peer.
hostname
[|any] Optional. Configures the peers’ hostname. The hostname options are:
•
– Specifies the hostname as Fully Qualified Domain Name (FQDN) or partial DN or
any other name
•
any – Peer name is not specified. If the hostname is ‘any’ this tunnel is considered as responder
only and will allow incoming connection from any host.
ipsec-secure
{gw [|]} After specifying the peer hostname, optionally specify the IPSec settings:
•
ipsec-secure – Optional. Enables auto IPSec
•
gw – Optional. Configures IPSec gateway IP address or hostname
•
– Configures IPSec gateway’s IP address
•
– Configures IPSec gateway’s hostname