Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 678)

Brocade Mobility RFS Controller CLI Reference Guide 665
53-1003098-01
7
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#lldp transmit
Related Commands:
mac-auth
interface-config-instance
Enables authentication of MAC addresses on the selected wired port. Devices using this profile will
be able be to authenticate the MAC addresses of devices connecting to this GE interface
When enabled, this feature authenticates the source MAC address of a device, connecting to this
interface, with a RADIUS server. For more information on enabling this feature see,
mac-auth .
To enable MAC address authentication on a device, execute the mac-auth command on the device
configuration mode.
Supported in the following platforms:
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
mac-auth
Parameters
None
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#mac-auth
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#show
context
interface ge1
mac-auth
ip dhcp trust
qos trust dscp
qos trust 802.1p
channel-group 1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge5)#mac-auth
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge5)#
rfs4000-229D58(config-device-00-23-68-22-9D-58-if-ge5)#show context
interface ge5
switchport mode access
switchport access vlan 1
dot1x authenticator host-mode single-host
dot1x authenticator guest-vlan 5
dot1x authenticator port-control auto
mac-auth
rfs4000-229D58(config-device-00-23-68-22-9D-58-if-ge5)#
no Disables or reverts interface settings to their default