Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 136)

Brocade Mobility RFS Controller CLI Reference Guide 119
53-1003098-01
3
dhcp 1 message-type request option-codes exact hexstring 5e4d36780b3a7f
!
client-identity-group ClientIdentityGroup
client-identity TestClientIdentity precedence 1
!
ip access-list BROADCAST-MULTICAST-CONTROL
permit tcp any any rule-precedence 10 rule-description "permit all TCP
traffic"
permit udp any eq 67 any eq dhcpc rule-precedence 11 rule-description "permit
$
deny udp any range 137 138 any range 137 138 rule-precedence 20
rule-descripti$
deny ip any 224.0.0.0/4 rule-precedence 21 rule-description "deny IP
multicast"
deny ip any host 255.255.255.255 rule-precedence 22 rule-description "deny IP
$
[ Read 549 lines ]
^G Get Help ^O WriteOut ^R Read File ^Y Prev Page ^K Cut Text ^C Cur Pos
^X Exit ^J Justify ^W Where Is ^V Next Page ^U UnCut Txt ^T To Spell
enable
Privileged Exec Mode Commands
Turns on (enables) the privileged mode command set. This command does not do anything in the
Privilege Executable mode.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
enable
Parameters
None
Example
rfs7000-37FABE#enable
rfs7000-37FABE#
erase
Privileged Exec Mode Commands
Erases a device’s (wireless controller, access point, and service platform) file system. Erases the
content of the specified storage device. Also erases the startup configuration to restore the device
to its default.
Supported in the following platforms: