Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 20)

Brocade Mobility RFS Controller CLI Reference Guide 1
53-1003098-01
Chapter
1
INTRODUCTION
This chapter describes the commands available within a device’s Command Line Interface (CLI)
structure. CLI is available for wireless controllers, access points (APs), and service platforms.
Access the CLI by using:
• A terminal emulation program running on a computer connected to the serial port on the
device (access point, wireless controller, and service platform).
• A Telnet session through Secure Shell (SSH) over a network.
Configuration for connecting to a Controller using a terminal emulator
If connecting through the serial port, use the following settings to configure your terminal emulator:
When a CLI session is established, complete the following (user input is in bold):
login as:
administrator’s login password:
User Credentials
Use the following credentials when logging into a device for the first time:
When logging into the CLI for the first time, you are prompted to change the password.
Examples in this reference guide
Examples used in this reference guide are generic to each supported wireless controller, service
platform, and AP model. Commands that are not common, are identified using the notation
“Supported in the following platforms.” For an example, see below:
Supported in the following platforms:
• Wireless Controller – Brocade Mobility RFS6000
The above example indicates the command is only available for a Brocade Mobility RFS6000 model
wireless controller.
Bits Per Second 19200
Data Bits 8
Parity None
Stop Bit 1
Flow Control None
User Name admin
Password admin123