Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 509)

Brocade Mobility RFS Controller CLI Reference Guide 495
53-1003098-01
6
rfs7000-37FABE(config)#
reload
show commands
Displays scheduled reload information for a specific device
NOTE
This command is not present in the USER EXEC mode.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show reload {on }
Parameters
show reload {on }
Example
rfs7000-37FABE(config)#show reload on rfs7000-37FABE
No reload is scheduled.
rfs7000-37FABE(config)#
rf-domain-manager
show commands
Displays RF Domain manager selection details
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
reload
{on
E>} Displays scheduled reload information for a specified device
•
on – Optional. Displays configuration on a specified device
•
– Specify the name of the AP, wireless controller, service platform, or
RF Domain.