Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 900)

888 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
11
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [deny|permit]
no deny precedence <1-1000>
no deny precedence <1-1000>
no permit precedence <1-1000>
no permit precedence <1-1000>
Parameters
deny precedence <1-1000>
deny precedence <1-1000>
no permit precedence <1-1000>
no permit precedence <1-1000>
Example
The following example shows the association ACL policy ‘test’ settings before
the ‘no’ commands is executed:
rfs7000-37FABE(config-assoc-acl-test)#show context
association-acl-policy test
no deny Removes a single device or a set of devices from the deny list
To remove a single device, enter its MAC address in the parameter.
precedence <1-1000> Specifies the rule precedence
•
<1-1000> – Specify the value from 1 - 1000.
no deny Removes a single device or a set of devices from the deny list
To remove a set of devices, enter the MAC address range.
Specify the first MAC address in the range.
Specify the last MAC address in the range.
precedence <1-1000> Specifies the rule precedence
•
<1-1000> – Specify a value from 1 - 1000.
no permit Removes a single device or a set of devices from the permit list
To remove a single device, enter its MAC address in the parameter.
precedence <1-1000> Specifies the rule precedence
•
<1-1000> – Specify a value from 1 - 1000.
no permit Removes a single device or a set of devices from the permit list
To remove a set of devices, enter the MAC address range.
Specify the first MAC address in the range.
Specify the last MAC address in the range.
precedence <1-1000> Specifies the rule precedence
•
<1-1000> – Specify a value from 1 - 1000.