Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1278)

1270 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
data-rates [2.4GHz|5GHz]
data-rates 2.4GHz [b-only|bg|bgn|default|g-only|gn]
data-rates 2.4GHz custom (1|11|12|18|2|24|36|48|5.5|54|6|9|basic-1|basic-11|
basic-12|basic-18|basic-2|basic-24|basic-36|basic-48|basic-5.5|basic-54|basic
-6|
basic-9|mcs0-15|mcs0-7|mcs8-15|basic-mcs0-7)
data-rates 5GHz [a-only|an|default]
data-rates 5GHz custom
(12|18|24|36|48|54|6|9|basic-1|basic-11|basic-12|basic-18|
basic-2|basic-24|basic-36|basic-48|basic-5.5|basic-54|basic-6|basic-9|mcs0-15
|
mcs0-7|mcs8-15|basic-mcs0-7)
Parameters
data-rates 2.4GHz [b-only|bg|bgn|default|g-only|gn]
data-rates 2.4GHz Configures preset data rates for the 2.4 GHz frequency.
b-only Configures data rate for the meshpoint using 802.11b only rates.
bg Configures data rate for the meshpoint using 802.11b and 802.11g rates.
default Configures data rate for the meshpoint at a pre-configured default rate for this frequency.
g-only Configures data rate for the meshpoint using 802.11g only rates.
gn Configures data rate for the meshpoint using 802.11g and 802.11n rates.