Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1243)

Brocade Mobility RFS Controller CLI Reference Guide 1235
53-1003098-01
24
Configures specified OSPF interface as passive. This option is disabled by default.
A passive interface receives routing updates, but does not transmit them.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
passive [|all|vlan <1-4094>]
Parameters
passive [|all|vlan <1-4094>]
Example
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#passive vlan 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
router ospf
ospf enable
network 1.2.3.0/24 area 4.5.6.7
area 0.0.0.4
auto-cost reference-bandwidth 1
default-information originate metric 1 metric-type 2
passive vlan1
ip default-gateway priority 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
redistribute
router-mode
Specifies the route types redistributed by OSPF
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Enables the OSPF passive mode on the interface specified by the parameter
all Enables the OSPF passive mode on all the L3 interfaces
vlan <1-4094> Enables the OSPF passive mode on the specified VLAN interface
•
<1-4094> – Specify the VLAN interface ID from 1 - 4094.
no Disables the OSPF passive mode on a specified interface