Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1138)

1130 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
20
rfs7000-37FABE(config-smart-rf-policy-test)#show context
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
assignable-power 5GHz min 8
assignable-power 5GHz max 20
channel-list 2.4GHz 1,12
rfs7000-37FABE(config-smart-rf-policy-test)#
Related Commands:
channel-width
smart-rf-policy
Selects the channel width for Smart RF configuration
NOTE
In addition to 20 MHz and 40 MHz, AP82XX also provides support for 80 MHz channels.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
channel-width [2.4GHz|5GHz]
channel-width 2.4GHz [20MHz|40MHz|auto]
channel-width 5GHz [20MHz|40MHz|80MHz|auto]
Parameters
channel-width [2.4GHz|5GHz] [20MHz|40MHz|auto]
Usage Guidelines:
no Removes the channel list for the selected frequency
2.4GHz
[20MHz|40MHz|
auto] Assigns the channel width for the 2.4 GHz band
•
20MHz – Assigns the 20 MHz channel width. This is the default setting.
•
40MHz – Assigns the 40 MHz channel width
•
auto – Assigns the best possible channel in the 20 MHz or 40 MHz channel width
5GHz
[20MHz|40MHz|80MHz|
auto] Assigns the channel width for the 5.0 GHz band
•
20MHz – Assigns the 20 MHz channel width
•
40MHz – Assigns the 40 MHz channel width. This is the default setting.
•
auto – Assigns the best possible channel in the 20 MHz, 40 MHz, or 80 MHz channel width