Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1141)

Brocade Mobility RFS Controller CLI Reference Guide 1133
53-1003098-01
20
Related Commands:
enable
smart-rf-policy
Enables a Smart RF policy
Use this command to enable this Smart RF policy. Once enabled, the policy can be assigned to a RF
Domain supporting a network.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
enable
Parameters
None
Example
rfs7000-37FABE(config-smart-rf-policy-test)#enable
Related Commands:
group-by
smart-rf-policy
Enables grouping of APs on the basis of their location in a building (floor) or an area
Within a large RD Domain, grouping of APs (within an area or on the same floor in a building)
facilitates statistics gathering and troubleshooting.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
no Disables recovery from coverage hole errors
no Disables a Smart RF policy