Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 580)

Brocade Mobility RFS Controller CLI Reference Guide 567
53-1003098-01
7
no
bridge-vlan-mode commands
Negates a command or reverts settings to their default. The no command, when used in the bridge
VLAN mode, negates the VLAN bridge settings or reverts them to their default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
[bridging-mode|description|edge-vlan|firewall|ip|l2-tunnel-broadcast-optimiza
tion|
stateful-packet-inspection-l2|tunnel|tunnel-over-level2|use]
no
[bridging-mode|description|edge-vlan|firewall|l2-tunnel-broadcast-optimizatio
n|
stateful-packet-inspection-l2|tunnel-over-level12]
no ip [arp|dhcp|igmp]
no ip [arp|dhcp] trust
no ip igmp snooping {forward-unknown-multicast|mrouter|querier}
no ip igmp snooping {forward-unknown-multicast}
no ip igmp snooping {mrouter [interface |learn pin-dvmrp]}
no ip igmp snooping {querier {address|max-response-time|timer expiry|version}}
no tunnel unknown-unicast
no use [ip-access-list|mac-access-list] tunnel out
Parameters
no
[bridging-mode|description|edge-vlan|firewall|l2-tunnel-broadcast-optimizatio
n|
stateful-packet-inspection-12|tunnel-over-level2]
no bridging-mode Resets the bridging mode to ‘auto’
no description Removes the VLAN’s description
no edge-vlan Disables the edge VLAN mode
no firewall Disables the VLAN’s firewall
no
l2-tunnel-broadcast-optimizati
on Disables broadcast optimization