Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 792
Brocade Mobility RFS Controller CLI Reference Guide
779
53-1003098-01
7
Configures static address resolution protocol
Enables network configuration device learning
Autogenerates a unique local ID for devices using this profile. When executed in the device
configuration mode, this command generates a unique ID for the logged device.
Configures the autoinstall feature
Configures bridge specific commands
Configures captive portal advanced Web page uploads on a profile or device
Enables CDP on a device
Configures a cluster name
Enables configuration persistence across reloads
Configures a wireless controller or service platform
Monitors user configured IP addresses and logs their status
Configures crypto settings
Configures device firmware upgrade settings on this profile
Configures 802.1x standard authentication controls
Configures an IP DSCP to 802.1p priority mapping for untagged frames
Configures e-mail notification
Enables checking of a device’s firmware version before attempting adoption or clustering
Configures the environmental sensor device settings
Displays system event messages
Enables the export of the startup.log file after every boot
Sets the floor name where the system is located
Enables GRE tunneling on this device
Configures HTTP analysis settings
Configures an interface
Configures IP components
Defines the Layer 2 Tunnel Protocol (L2TP) protocol for tunneling layer 2 payloads using VPNs
Configures L3e Lite Table with this profile
Turns device LEDs on or off
Configures LED-timeout timer. This command is specific to the NX9000 series service platforms.
Auto downgrades a legacy device firmware
Auto upgrades a legacy device firmware
Configures Link Layer Discovery Protocol (LLDP)
Configures load balancing parameters
Modifies message logging
Configures the MAC address table
Enables 802.1x port-based user authentication on this device
Configures the memory profile used on the device