Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1145
Brocade Mobility RFS Controller CLI Reference Guide
1137
53-1003098-01
20
neighbor-recovery {power-hold-time <0-3600>}
neighbor-recovery {power-threshold [2.4Ghz|5Ghz] <-85--55>}
Example
rfs7000-37FABE(config-smart-rf-policy-test)#neighbor-recovery power-threshold
2.4 -82
rfs7000-37FABE(config-smart-rf-policy-test)#neighbor-recovery power-threshold
5 -65
rfs7000-37FABE(config-smart-rf-policy-test)#show context
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
group-by floor
sensitivity custom
assignable-power 5GHz min 8
assignable-power 5GHz max 20
channel-list 2.4GHz 1,12
channel-width 5GHz auto
interference-recovery channel-switch-delta 5GHz 5
neighbor-recovery power-threshold 5GHz -65
neighbor-recovery power-threshold 2.4GHz -82
coverage-hole-recovery snr-threshold 5GHz 1
rfs7000-37FABE(config-smart-rf-policy-test)#
Related Commands:
no
Negates a command or sets its default. When used in the config Smart RF policy mode, the
no
command disables or resets Smart RF settings.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
power-hold-time
Optional. Specifies the minimum time, in seconds, between two power changes on a radio during
neighbor-recovery
<0-3600>
Sets the time from 0 - 3600 sec. The default is 3600 seconds.
power-threshold
Optional. Specifies the power threshold based on the recovery performed
The 2.4 GHz/5.0 GHz radio uses as a maximum power increase threshold if the radio is required to
increase its output power to compensate for a failed radio within its wireless radio coverage area.
[2.4GHz|5GHz]
Selects the band
•
2.4GHz – Selects the 2.4 GHz band
•
5GHz – Selects the 5.0 GHz band
<-85--55>
Specify the threshold value
•
<-85--55> – Sets the power threshold from -85 dBm - -55 dBm. The default is -70 dBm for
both the 2.4 GHz and 5.0 GHz bands.
Disables recovery from faulty neighbor radios