Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 261)

Brocade Mobility RFS Controller CLI Reference Guide 245
53-1003098-01
4
Example
rfs7000-37FABE(config-event-system-policy-event-testpolicy)#event aaa
radius-discon-msg email on forward-to-switch default snmp default syslog
default
rfs7000-37FABE(config-event-system-policy-event-testpolicy)#
rfs7000-37FABE(config-event-system-policy-testpolicy)#show context
event-system-policy test
event aaa radius-discon-msg email on
rfs7000-37FABE(config-event-system-policy-testpolicy)#
Related Commands:
no
event-system-policy-mode commands
Negates an event monitoring configuration
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no event [email|forward-to-switch|snmp|syslog]
[default|on|off]
Parameters
no event [email|forward-to-switch|snmp|syslog]
[default|on|off]
snmp Logs an SNMP event
syslog Logs an event to syslog
default Performs the default action for the event
off Switches the event off, when the event happens, and no action is performed
on Switches the event on, when the event happens, and the configured action is taken
no Resets or disables event monitoring
no event
Removes the specified event monitoring activity
•
– Select the event type.
•
– After selecting the event type, specify the event name.
NOTE: The system stops network monitoring for the occurrence of the specified event and no notification is
sent if the event occurs.