Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 586
Brocade Mobility RFS Controller CLI Reference Guide
573
53-1003098-01
7
Configures captive portal advanced Web page uploads on this profile. These Web pages are
uploaded to access points supporting the captive portal.
A captive portal is a means of providing guests temporary and restrictive access to the controller
managed wireless network. A captive portal provides secure authenticated controller access by
capturing and re-directing a wireless user’s Web browser session to a captive portal login page,
where the user must enter valid credentials. Once the user is authenticated and logged into the
controller managed network, additional agreement, welcome, and fail pages provide the
administrator with options to control the captive portal’s screen flow and user appearance.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
captive-portal page-upload count <1-20>
Parameters
captive-portal page-upload count <1-20>
Example
rfs7000-37FABE(config-profile-default-rfs7000)#captive-portal page-upload
count 10
rfs7000-37FABE(config-profile-default-rfs7000)#
cdp
Uses Cisco Discovery Protocol (CDP) as a layer 2 protocol that discovers information about
neighboring network devices
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
cdp [holdtime|run|timer]
page-upload
Enables captive portal advanced Web page upload
count <1-20>
Sets the maximum number of APs that can be uploaded concurrently
•
<1-20> – Set a value from 1 - 20.