Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 177)

Brocade Mobility RFS Controller CLI Reference Guide 161
53-1003098-01
4
NOTE
For more information on the AAA-TACACS policy commands, see Chapter 26, AAA-TACACS-POLICY.
advanced-wips-policy
Global Configuration Commands
Configures an advanced Wireless Intrusion Prevention System (WIPS) policy. WIPS prevents
unauthorized access to a network.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
advanced-wips-policy
Parameters
advanced-wips-policy
Example
rfs7000-37FABE(config)#advanced-wips-policy test
rfs7000-37FABE(config-advanced-wips-policy-test)#?
Advanced WIPS policy Mode commands:
event Configure event detection
no Negate a command or set its defaults
server-listen-port Configure local WIPS server listen port number
terminate Add a device to the list of devices to be terminated
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-advanced-wips-policy-test)#
Related Commands:
AME> Specify the advanced WIPS policy name. If the policy does not exist, it is created.
no Removes an existing Advanced WIPS policy