Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 618)

Brocade Mobility RFS Controller CLI Reference Guide 605
53-1003098-01
7
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
remoteid [address |dn |email |fqdn |string ]
Parameters
remoteid [address |dn |email |fqdn |string ]
Example
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#remoteid dn
San
Jose
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#show context
crypto ikev1 peer peer1
ip address 172.16.10.12
remoteid dn SanJose
localid email [email protected]
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#remoteid
address 157.235.209.63
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#show context
crypto ikev2 peer peer1
remoteid address 157.235.209.63
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#
use
crypto-ikev1/ikev2-peer commands
Associates IKEv1/IKEv2 policy configuration settings with IKEv1/IKEv2 peer
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
address Configures the remote IKEv1/IKEV2 peer’s IP address. The IP address is used as the peer’s remote identity.
dn Configures the remote peer’s distinguished name. For example, "C=us ST= L=
O= OU=". The maximum length is 128 characters.
email Configures the remote peer’s e-mail address. The maximum length is 128 characters.
fqdn Configures a peer’s FQDN. The maximum length is 128 characters.
string Configures a peer’s identity string. The maximum length is 128 characters.