Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 797)

784 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Parameters
power-config [af-option|at-option] [range|throughput]
power-config mode [auto|3af]
Example
rfs7000-37FABE(config-profile-defalut-rfs7000)#power-config af-option range
% Warning: AP must be restarted for power-management change to take effect.
rfs7000-37FABE(config-profile-defalut-rfs7000)#
rfs7000-37FABE(config-profile-defalut-rfs7000)#power-config at-option
throughput
% Warning: AP must be restarted for power-management change to take effect.
rfs7000-37FABE(config-profile-defalut-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000)#power-config af-option range
% Error on default-rfs7000: AP power configuration not available for rfs7000
platform
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
preferred-controller-group
Profile Config Commands
Specifies the controller group preferred for adoption
af-option
[range|throughput] Configures the 802.3.af power mode option. The options are:
•
range – Configures the af power range mode. This mode provides higher power but fewer transmission
(tx) chains.
Select range when range is preferred over performance for broadcast/multicast (group) traffic. The data
rates used for range are the lowest defined basic rates.
•
throughput – Configures the af power throughput mode. This mode provides lower power but has more
tx chains. This is the default setting.
Select throughput to transmit packets at the radio’s highest defined basic rate (based on the radio’s current
basic rate settings). This option is optimal in environments where transmission range is secondary to
broadcast/multicast transmission performance.
at-option
[range|throughput] Configures the 802.3 at power mode option. The options are:
•
range – Configures the at power range mode. This mode provides higher power but fewer tx chains.
Select range when range is preferred over performance for broadcast/multicast (group) traffic. The data
rates used for range are the lowest defined basic rates.
•
throughput – Configures the at power throughput mode. This mode provides lower power but has more
tx chains. This is the default setting.
Select throughput to transmit packets at the radio’s highest defined basic rate (based on the radio’s current
basic rate settings). This option is optimal in environments where transmission range is secondary to
broadcast/multicast transmission performance.
mode [auto|3af] Configures the AP power mode
•
3af – Forces an AP to power up in the 802.3af power mode
•
auto – Sets the detection auto mode (default setting)
The automatic power-config mode enables an access point to automatically determine the best power
configuration based on the available power budget.
no Reverts the power mode setting on this profile to default