Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 1216

1208

Brocade Mobility RFS Controller CLI Reference Guide

53-1003098-01

peer <1-2> {ip-address } {hostname|ipsec-secure|router-id|udp}

peer <1-2> {ipsec-secure} {gw [|]}

router-id [||any] After specifying the peer hostname, optionally specify router ID settings:

•

router-id – Optional. Configures the peer’s router ID in one of the following formats:

•

– Peer router ID in the IP address (A.B.C.D) format

•

– Peer router ID range (for example, 100-120)

•

any – Peer router ID is not specified. This allows incoming connection from any router ID.

udp
{ipsec-secure gw|
port <1-65535>
{ipsec-secure}}

After specifying the peer hostname, optionally specify UDP settings:
The UDP option configures the encapsulation mode for this tunnel.

•

UDP – Optional. Configures UDP encapsulation (default encapsulation is IP)

•

ipsec-secure gw – Optional. Enables auto IPSec

•

port <1-65535> {ipsec-secure} – Optional. Configures the peer’s UDP port running the L2TPv3

service from 1 - 65535. After specifying the peer UDP port, optionally configure
the IPSec settings.

peer <1-2>

Configures the tunnel’s peer ID from 1 - 2. At any time the tunnel is established with only one peer.

ip-address

Optional. Configures the peer’s IP address in the A.B.C.D format

hostname [|any]

After specifying the peer IP address, optionally specify the peer’s hostname:
Optional. Configures the peers’ hostname. The hostname options are:

•

– Specifies the hostname as FQDN or partial DN

•

any – Peer name is not specified. If the hostname is ‘any’ this tunnel is considered as responder
only and will allow incoming connection from any host.

ipsec-secure
{gw [|]}

After specifying the peer IP address, optionally specify the IPSec settings:

•

ipsec-secure – Optional. Enables auto IPSec

•

gw – Optional. Configures IPSec gateway IP address or hostname

•

– Configures IPSec gateway’s IP address

•

– Configures IPSec gateway’s hostname

router-id
[||any]

After specifying the peer IP address, optionally specify the router ID using one of the following options:

•

router-id – Optional. Configures the peer’s router-id in one of the following formats:

•