Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1135)

Brocade Mobility RFS Controller CLI Reference Guide 1127
53-1003098-01
20
Table 18 summarizes Smart RF policy configuration commands.
area
smart-rf-policy
Configures the channel list and power for a specified area
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
TABLE 18 Smart-RF-Policy-Config Commands
Command Description Reference
area Configures the channel list and power for a specified area page 1127
assignable-power Specifies the power range during power assignment page 1128
channel-list Assigns the channel list for the selected frequency page 1129
channel-width Selects the channel width for Smart RF configuration page 1130
coverage-hole-recov
ery Enables recovery from errors page 1131
enable Enables a Smart RF policy page 1133
group-by Configures grouping parameters page 1133
interference-recover
y Recovers issues due to excessive noise and interference page 1134
neighbor-recovery Enables recovery from errors due to faulty neighbor radios page 1136
no Negates a command or reverts settings to their default page 1137
sensitivity Configures Smart RF sensitivity page 1139
smart-ocs-monitorin
g Applies smart off channel scanning instead of dedicated detectors page 1140
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug (config-if) instance
configurations
page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425