Sensor-server – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 319
Brocade Mobility RFS Controller CLI Reference Guide
303
53-1003098-01
4
overrides-wlan
<0-8192>}|wpa-wpa2-psk
Example
rfs7000-37FABE(config-rf-domain-default)#override-wlan test vlan-pool 2 limit
20
rfs7000-37FABE(config-rf-domain-default)#show context
rf-domain default
contact Bob+919621212577
country-code in
override-smartrf channel-list 2.4GHz 1,2,3
override-wlan test vlan-pool 2 limit 20
layout area Ecospace floor Floor5 map-location www.fiestfloor.com units
meters
rfs7000-37FABE(config-rf-domain-default)#
Related Commands:
sensor-server
Configures an AirDefense sensor server on this RF Domain. Sensor servers allow network
administrators to monitor and download data from multiple sensors remote locations using
Ethernet TCP/IP or serial communications. This enables administrators to respond quickly to
interferences and coverage problems.
The Brocade Wireless Intrusion Protection System (WIPS) protects the controller managed network,
wireless clients and access point radio traffic from attacks and unauthorized access. WIPS
provides tools for standards compliance and around-the-clock wireless network security in a
distributed environment. WIPS allows administrators to identify and accurately locate attacks,
rogue devices and network vulnerabilities in real time and permits both a wired and wireless
lockdown of wireless device connections upon acknowledgement of a threat.
In addition to dedicated Brocade AirDefense sensors, an access point radio can function as a
sensor and upload information to a dedicated WIPS server (external to the controller). Unique WIPS
server configurations can be used by RF Domains to ensure a WIPS server configuration is
available to support the unique data protection needs of individual RF Domains.
Configures the WLAN name
The name should not exceed 32 characters and should represent the WLAN coverage area. After creating the
WLAN, configure its override parameters.
ssid
Configures a override SSID associated with this WLAN
The SSID should not exceed 32 characters.
vlan-pool <1-4094>
{limit <0-8192>}
Configures the override VLANs available to this WLAN
•
<1-4094> – Specify the VLAN ID from 1 - 4094.
•
limit <0-8192> – Optional. Sets a limit to the number of users on this VLAN from 0 - 8192. The
default is 0.
wpa-wpa2-psk
Configures the WPA-WPA2 pre-shared key or passphrase for this WLAN
•
Resets the override WLAN settings its default