Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 259)

Brocade Mobility RFS Controller CLI Reference Guide 243
53-1003098-01
4
nsm Configures Network Service Module (NSM) related event message
•
dhcpc-err – Event DHCP certification error message
•
dhcpdefrt – Event DHCP defrt message
•
dhcpip – Event DHCP IP message
•
dhcpipchg – Event DHCP IP change message
•
dhcpipnoadd – Event DHCP IP overlaps static IP address message
•
dhcplsexp – Event DHCP lease expiry message
•
dhcpnak – Event DHCP server returned DHCP NAK response
•
dhcpnodefrt – Event interface no default route message
•
if-failback – Event interface failback message
•
if-failover – E VENT I nterface failover message
•
ifdown – Event interface down message
•
ifipcfg – Event interface IP config message
•
ifup – Event interface up message
•
nsm-ntp – Event translate host name message
pm Configures process monitor module related event messages
•
procid – Event proc ID message
•
procmaxrstrt – Event proc max restart message
•
procnoresp – Event proc no response message
•
procrstrt – Event proc restart message
•
procstart – Event proc start message
•
procstop – Event proc stop message
•
procsysrstrt – Event proc system restart message
•
startupcomplete – Event startup complete message
radconf Configures RADIUS configuration daemon related event messages
•
could-not-stop-radius – Event could not stop RADIUS server message
•
radiusdstart – Event RADIUS server started message
•
radiusdstop – Event RADIUS server stopped message
radio Configures radio module related event messages
•
acs-scan-complete – Event ACS scan completed
•
acs-scan-started – Event ACS scan started
•
channel-country-mismatch – Event channel and country of operation mismatch message
•
radar-det-info – Detected radar info message
•
radar-detected – Event radar detected message
•
radar-scan-completed – Event radar scan completed message
•
radar-scan-started – Event radar scan started message
•
radio-antenna-error – Event invalid antenna type on this radio message
•
radio-antenna-setting – Event antenna type setting on this radio message
•
radio-state-change – Event radio state change message
•
resume-home-channel – Event resume home channel message
smrt Configures SMART RF module related event messages
•
calibration-done – Event calibration done message
•
calibration-started – Event calibration started message
•
channel-change – Event channel change message
•
config-cleared – Configuration cleared event message
•
cov-hole-recovery – Event coverage hole recovery message
•
cov-hole-recovery-done – Event coverage hole recovery done message
•
interference-recovery – Event interference recovery message
•
neighbor-recovery – Event neighbor recovery message
•
power-adjustment – Event power adjustment message
•
root-recovery – Event meshpoint root recovery message