Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 296)

280 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
Example
rfs7000-37FABE(config)#radius-server-policy testpolicy
rfs7000-37FABE(config-radius-server-policy-testpolicy)#?
Radius Configuration commands:
authentication Radius authentication
chase-referral Enable chasing referrals from LDAP server
crl-check Enable Certificate Revocation List( CRL ) check
ldap-group-verification Enable LDAP Group Verification setting
ldap-server LDAP server parameters
local RADIUS local realm
nas RADIUS client
no Negate a command or set its defaults
proxy RADIUS proxy server
session-resumption Enable session resumption/fast reauthentication by
using cached attributes
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-radius-server-policy-testpolicy)#
NOTE
For more information on RADIUS server policy commands, see Chapter 17, RADIUS-POLICY .
Related Commands:
radius-user-pool-policy
Global Configuration Commands
Configures a RADIUS user pool
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
radius-user-pool-policy
no Removes an existing RADIUS server policy