Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1239)

Brocade Mobility RFS Controller CLI Reference Guide 1231
53-1003098-01
24
Parameters
auto-cost reference-bandwidth <1-4294967>
Example
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#auto-cost
reference-bandwidth 1
Please make sure that auto-cost reference-bandwidth is configured uniformly on
all routers
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
router ospf
area 0.0.0.4
auto-cost reference-bandwidth 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
default-information
router-mode
Controls the distribution of default route information. Use the default-information > originate
command to advertise a default route in the routing table.
This option is disabled by default. When enabled, the default route becomes a distributed route.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
default-information originate {always|metric|metric-type}
default-information originate {always|metric <0-16777214>|metric-type [1|2]}
{(metric <0-16777214>|metric-type[1|2])}
Parameters
reference-bandwidth
<1-4294967> Defines the reference bandwidth in Mbps
•
<1-4294967> – Specify the reference bandwidth value from1 - 4294967.
no Removes auto-cost reference bandwidth settings