Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 672)

Brocade Mobility RFS Controller CLI Reference Guide 659
53-1003098-01
7
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#show context
interface ge1
ip dhcp trust
qos trust dscp
qos trust 802.1p
channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Related Commands:
description
interface-config-instance
Configures a description for a defined interface
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
description [|]
Parameters
description [|]
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#description “This is
GigabitEthernet interface for Royal King”
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#show context
interface ge1
description This\ is\ GigabitEthernet\ interface\ for\ Royal\ King
ip dhcp trust
qos trust dscp
qos trust 802.1p
channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
no Removes a channel group
Configures the maximum length (number of characters) of the interface description
Configures a unique description for this interface. The description should not exceed the length specified by
the parameter