Meshpoint – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 271
Brocade Mobility RFS Controller CLI Reference Guide
255
53-1003098-01
4
Syntax:
management-policy
Parameters
management-policy
Example
rfs7000-37FABE(config)#management-policy test
rfs7000-37FABE(config-management-policy-test)#?
Management Mode commands:
aaa-login Set authentication for logins
banner Define a login banner
ftp Enable FTP server
http Hyper Text Terminal Protocol (HTTP)
https Secure HTTP
idle-session-timeout Configure idle timeout for a configuration session
(GUI or CLI)
no Negate a command or set its defaults
privilege-mode-password Set the password for entering CLI privilege mode
restrict-access Restrict management access to the device
snmp-server SNMP
ssh Enable ssh
telnet Enable telnet
user Add a user account
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-management-policy-test)#
Related Commands:
NOTE
For more information on Management policy configuration, see
meshpoint
Creates a new meshpoint and enters its configuration mode. Use this command to select and
configure existing meshpoints.
Specify the management policy name. If the policy does not exist, it is created.
Removes an existing management policy