Mint – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 785
772
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Parameters
min-misconfiguration-recovery-time <60-3600>
Example
rfs7000-37FABE(config-profile-default-rfs7000)#min-misconfiguration-recovery-
time 200
% Error on default-rfs7000: Unknown config-item (id:min_misconf_recovery_time)
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
mint
Configures MiNT protocol commands
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
mint [dis|level|link|mlcp|spf-latency|tunnel-controller-load-balancing]
mint dis [priority-adjustment <-255-255>|strict-evis-reachability]
mint level 1 area-id <1-16777215>
mint link [force|ip|listen|vlan]
mint link force ip
mint link force ip
<2-600>|
cost <1-10000>|hello-interval <1-120>|ipsec-secure {gw}}
mint link [listen ip
<1-10000>|
hello-interval <1-120>|ipsec-security {gw}|level [1|2]}
mint link ip
hello-interval <1-120>|ipsec-security {gw}|level [1|2]}
mint mlcp [ip|vlan]
mint spf-latency <0-60>
min-misconfiguration-recovery
-time <60-3600>
Configures the minimum connectivity (with the associated device) verification interval
•
<60-3600> – Specify a value from 1 - 3600 seconds (default is 60 seconds).
Resets setting to default (60 seconds)