Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 684)

Brocade Mobility RFS Controller CLI Reference Guide 671
53-1003098-01
7
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#spanning-tree
force-version 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#spanning-tree guard
root
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#spanning-tree mst 2
port-priority 10
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#show context
interface ge1
description This\ is\ GigabitEthernet\ interface\ for\ Royal\ King
duplex full
spanning-tree bpduguard enable
spanning-tree bpdufilter disable
spanning-tree force-version 1
spanning-tree guard root
spanning-tree mst 2 port-priority 10
--More--
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Related Commands:
speed
interface-config-instance
Specifies the speed of a FastEthernet (10/100) or GigabitEthernet (10/100/1000) port
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
speed [10|100|1000|auto]
Parameters
speed [10|100|1000|auto]
Usage Guidelines:
no Removes spanning tree settings configured on this interface
10 Forces 10 Mbps operation
100 Forces 100 Mbps operation
1000 Forces 1000 Mbps operation
auto Port automatically detects its operational speed based on the port at the other end of the link. Auto
negotiation is a requirement for using 1000BASE-T[3] according to the standard (default setting).